25.4.2015

Progress, progress...

Veneenveisto on nyt jatkunut 7 kuukautta ja hyvältä näyttää !! 

Iso koko on aiheuttanut sen että jokaisen runkolaudan ja kaarenpalan sovittamisessa ja työstössä kuluu aikaa jonkin verran suunniteltua enemmän. 

Tässä on esimerkiksi 7.runkolaudan höyläämistä. Tämän kolmesta osasta liimatun laudan pituus on n.13 metriä ja se ajettiin tasohöylän läpi n.8 kertaa...jopa verstaan ikkun piti poistaa jotta lauta mahtuu liikkumaan. Laudan paksuus on tuuman luokkaa.

---------------------------------------------------------------------------------------------------------------------------------

It has now been 7 months since the boatbuilding started and we are up to the 7th hull plank. It has taken a bit longer than estimated due to the physical size of every single piece of plank / section of a frame. 

It is very time consuming to work and move these large pieces into their location over and over again until a good and desired fit has been achieved.

Here is the 7th set of planks plank which were both glued out of three sections. The overall lenght of one plank is about 13 meters and we had to run it through the horizontal plane for about 8 times. We even had to remove the window to make sure it fits inside and through the plane...The hull thickness is about an inch.





Keula kohoaa jo ylväänä...The bow is starting to get its' shape !!







Tässä on jo 7.lauta paikalla. The 7th plank in place !!


Kuva tulevasta takahytistä...A view to the future aft cabin !!


Seuraavaksi alkaa kaarien teko ja joidenkin mallikaarien poisto. 

Now it's time to continue building the frames before the 8th set of planks are in place. Some of these temp.frames will be removed as well...